Microcom 48-466 - Manual (Page 41)

Chapter 5 Printer Commands
48-466 Operators Manual 35
^A ^D COMMAND
22 Change SW2: Software dip switch #2. Below is the ^AB sequence:
12345678
^Abxxxxxxxx
*******.)))),
******.)))),*
*****.)))),**
***** RRR
Power-up Label Format
*****
000=ALWAYS EPROM Format 1
*****
001=ROM or Saved Format File 1
*****
010=ROM or Saved Format File 2
*****
011=ROM or Saved Format File 3
*****
100=ROM or Saved Format File 4
*****
101=ROM or Saved Format File 5
*****
110=ROM or Saved Format File 6
*****
111=ROM or Saved Format File 7
****.))))Q
1=Use Saved Format File, 0=Rom Format
***.)))))Q
1=Print Button Enable, 0=Disable
**.))))))Q
1=Disable Button Use, 0=Enable
*.)))))))Q
1=>RESTARTED< Response Enable, 0=Disable
.))))))))Q
1=Clear Text Enable, 0=Disable
Position:
1 Clear Text Function: If enabled, all variable text strings will be erased when a ^D25
is processed.
2 >RESTARTED< Response: If the printer has been reset and this switch has been
enabled, the printer will respond with to the first poll by sending the >RESTARTED<
message. If additional enquiries are made the printer will respond normally. The
>RESTARTED< message is only sent once after reset.
3 Button Use: Set to 1, the printer will not allow button use, even for paper feed.
4 Print Button: If this is 0, the button can be used for paper feed, but cannot be used
to initiate label printing.
5 Power-up Format Type: Defines the power-up label format. This parameter
determines whether to use a saved format file for the power-up label, or a ROM
format (defined by positions 6, 7, and 8). The saved format file must be battery
backed to use the saved format file feature. Please consult your service organization
if changes or additions to the fixed ROM formats are required.
6,7,8 Power-up Label Format: These switches decide which format to use at power-up.