Microcom 48-466 User Manual

Page 39

Chapter 5

Printer Commands

48-466 Operators Manual

Enquiry Responses

TEXT

^ALPHA or CONTROL

CODE

DEFINITION

>RESTARTED<
>READY<
>DATA ERROR<
>LOW STOCK<
>LOW TEMP<
>OVER TEMP<
>OVER VDD<

^F
^U
^Y

^[
^\

Printer has been reset
Normal condition
Communication error
Out of labels
Head temperature is low
Head temperature is high
VDD voltage is high

Table 9

5.3

SENDING ^D PRINTER COMMANDS

Unless other-wise specified, these commands are entered by sending a ^DXX where XX is the
command number. It is followed by a carriage return or another control code. Some commands load
data or control numbers and are preceded by a ^AXX, where XX represents the data or control
number. Unless otherwise specified, command codes should precede or follow the actual format
layout. They should be placed before the ^D57 or just before the print command ^D3.

All commands not listed in 5.3.1 (the dip switches and non-volatile commands section) are not
retained when the printer is turned off and if desired, must be sent again upon power-up.

When possible, the following commands are grouped by function. See the quick reference
command summary in Appendix A for a listing by number.

Some commands can be substituted with equivalent control-codes. If this is the case, there will be
an equivalence statement in the description.

Example of Command usage:
^A3^D75^D35 (This sequence will print a batch of three labels).