Microcom 48-466 - Manual (Page 14)

Basic Operation Chapter 2
48-466 Operators Manual 8
Printer Serial #: 0-123456
Printed Labels: 8432
Total Labels: 8498
Printed Inches: 25296
Total Inches: 25494
Power On Hours: 897
Contrast Base: 115
Hard Switch Bank 1: 10100000
Soft Switch Bank 1: 10000001
Soft Switch Bank 2: 01010001
Soft Switch Bank 3: 00000000
Soft Switch Bank 4: 00000000
Soft Switch Bank 5: 10001011
Soft Switch Bank 6: 00000000
Comm1 Parameters: 9600-N-8-1
Comm2 Parameters: INACTIVE
RAM: 262144
Optional ROM: NONE
Cutter Installed: NO
Second Proc. Rev: 1.23
RAM Checksum: Enabled
48-466 REV 2.00 000000-0200 08/05/97
Status Label
Figure 4
2.1.3 PAPER-OUT MODE
When a paper out condition occurs, the printer will continuously beep and the red error indicator
will light. The front panel switch serves to load and realign the new label stock. Pressing and
holding the button will cause the printer to “Line Feed”. Pressing and quickly releasing the button
will cause a "Label Print". If the printer is in “Out of Paper” mode, the button will print a duplicate
of the last label printed. The previous label can be repeated until proper registration occurs. To
return to the pre-paper out condition, tap the button while the duplicate label is being printed. The
red error light should go out and normal printing may resume.