Microcom 428T - Manual (Page 67)

Chapter 4 Designing Labels with LDS
428T Operator’s Manual - 880037-0141 4-7
PRINT SPEED
DPS VALUE
MM PER
SECOND
INCHES PER
SECOND
INCHES PER
MINUTE
00 203.2 8.0 480
01 190.5 7.5 450
02 177.8 7.0 420
03 165.1 6.5 390
04 152.4 6.0 360
05 139.7 5.5 330
06 127.0 5.0 300
07 114.3 4.5 270
08 101.6 4.0 240
09 88.9 3.5 210
10 76.2 3.0 180
11 63.5 2.5 150
12 50.8 2.0 120
13 38.1 1.5 90
Table 4-1 DPS Values
4.4.7 LCB (Label Control Byte)
HFM, LSX, LSY, WEB, GAP, DPS, LCB , AGD, SPG, OFX, OFY
This parameter selects the method the printer uses for detecting registration marks on the
different media types. Theprinter printer has both upper (transmissive) and lower (reflective)
gap detectors as standard equipment. The following sections discuss the LCB settings for
the different media types.
4.4.7.1
Die-Cut and Blow-Hole Media (setting = 0)
A selection of “0” in the LCB parameter instructs the printer to detect the leading edge of a
die-cut label or a “blow-hole” to identify the start of the next label. In this method light from
the lower sensor passes through the stock to the detector in the upper sensor. This is
referred to as “transmissive” sensing. The label sample (Figure 4-2) is die-cut, therefore,
the LCB is set to “0”.
4.4.7.2
Continuous Media (setting = 2)
If the LCB parameter is set to a value of “2”, the printer will not search for a registration
mark. The gap detectors are only used for stock out conditions when set for continuous
media types. The printer will print all fields that contain data and then advance the media by
the amount specified in the SPG parameter of the header when the default AGD of “1” is
entered in the header. This means that fields that are left blank or text data for the
associating format fields are left empty will not print.