Microcom 428T - Manual (Page 167)

Chapter 8 Bar Codes
428T Operator’s Manual - 880037-0141 8-15
^D2
A
Data Matrix
^D3
NOTE: MULTIPLYING THE BARCODE GENERATED.
The barcode generated is based on a single dot width. For the barcode to be visible and to
scan properly, a reasonable multiplier must be used. Typical values for a multiplier are 8-
10. This is accomplished in the LDS1 format above on the line: 1,300,300,1,47,,,,10,10
Height Parameter- 0
This parameter is used to set the height of the Data Matrix symbol. Zero entry will invoke
auto sizing.
Width Parameter- 0
This parameter is used to set the width of the Data Matrix symbol. Zero entry will invoke
auto sizing.
Rotation - 1
0 = 0 degree rotation
1 = 180 degree counter clockwise rotation.
2 = 90 degree counter clockwise rotation.
3 = 270 degree counter clockwise rotation.
Symbol Size
Numeric
Capacity
Alphanumeric
Capacity
Binary Byte
Capacity
Auto --- --- ---
10 x 10 6 3 1
12 x 12 10 6 3
14 x 14 16 10 6
16 x 16 24 16 10
18 x 18 36 25 16
20 x 20 44 31 20
22 x 22 60 43 28
24 x 24 72 52 34
26 x 26 88 64 42
32 x 32 124 91 60
36 x 36 172 127 84
40 x 40 228 169 112
44 x 44 288 214 142
48 x 48 348 259 172
52 x 52 408 304 202
64 x 64 560 418 278
72 x 72 736 550 366
80 x 80 912 682 454
88 x 88 1152 862 574
96 x 96 1392 1042 694
104 x 104 1632 1222 814