Microcom 428T User Manual
Page 204
Printer Maintenance
Chapter 10
10-6
428T Operator’s Manual- 880037-0141
2. Release the Print Head Assembly and rotate to the open position.
3. Unscrew the Cutter or Tear Assembly using the mounting screw that is located in the
bottom center on the front of the Print Mechanism.
Figure 10-7 Cutter or Tear Assembly Mounting Screw
4. Squeeze the white plastic bushing together on both sides of the platen to release
from the sheet metal and lift the platen assembly up and out of the printer.
Figure 10-8 Removing the Platen
Cutter or Tear
Assembly
Mounting Screw.
Squeeze the tabs
together on both
sides and lift the
roller out of the
printer.