Microcom 428T - Manual (Page 46)

Getting Started Chapter 3
3-30 428T Operator’s Manual - 880037-0141
Press the Print Test Page and see a sample printout.
Micprinter also provides the ability to use the driver in a Command line environment. If your
application needs more than one install per PC, then the command line operation would
need to be used as the GUI will only support one install. Only one driver should be used at
a time. Issues may occur if more than one instance of Micprinter is used at the same time.
If a second printer is desired, then you could run two independent setups. You would need
to copy all of the supporting Micprinter files including the executable into separate
directories and specify the working directory of each as well.
From a Command line, type Micprint and press ENTER:
Reported to screen:
MICPrint.exe ver 2.8
Prints image based on attached BMP file and the registry entries..
Usage: MICPrint [] - Send a bmpfile to the printer using the
registry settings
MICPrint [ 0] - same as above but for use with -f, -p and
-d options
MICPrint [ 1] - Send a command line to the printer
MICPrint [ 2] - Send a command file to the printer
MICPrint - this message
Other options:
-f - Send the configuration to the printer as
a file (NOT READ FROM REGISTRY) This uses
the same exported setup file created from
the MICPrint Configuration utility
-p - Send the communication port to the
printer directly over-riding registry
and configuration file
-d - Directory for use with temporary files
Print Test
Page