Microcom 428T - Manual (Page 138)

Downloadable Graphics Chapter 6
6-2 428T Operator’s Manual - 880037-0141
6.3.1 BMP2MIC.exe GRAPHIC Conversion Utility Procedure
1. Execute the conversion utility from a DOS prompt.
2. Type the conversion utility name and required information at the command prompt.
Press [ENTER].
Note: Jet.bmp is used as an example for the . Enter your own GRAPHIC name in
its place. You may name the anything you wish as long it is less than 8
characters. An extension is not necessary.
3. Conversion is complete. Converted GRAPHIC file is ready to download to printer.
Microsoft(R) Windows 98
(C)Copyright Microsoft Corp 1981-1999.
C:\WINDOWS>cd\
C:\>BMP2MIC.exe
STEP 1
At the Command Prompt:
Type “BMP2MIC.exe”
Press [ENTER]
BMP2MIC - Convert BMP Graphic File to Microcom Printer Graphic
Rev. 2.01
Copyright 1998-2005 Microcom Corp., Westerville, Ohio
Use:
BMP2MIC
Where
is a BMP file
is the name of the desired output file
is one of the output types listed below
is the printer font slot number
is the maximum image width (printhead width) of the printer
is 0 for flash and 1 for ram
Output types are:
Type Output
1 Model 412 Standard ASCII (image 64K or less)
2 Model 412 Binary (any size image)
3 Model 412 Extended ASCII (any size image)
4 Model 466 ASCII (any size image)
5 Model 466 Binary (any size image)
6 Model x24 Extended Binary (any size image)
C:\>BMP2MIC Jet.bmp Jet.mic 6 100 832 0C:\>BMP2MIC Jet.bmp Jet.mic 6 100 832 0
STEP 2
At the Command Prompt:
Type “BMP2MIC” and follow
with required information.
Press (ENTER)
Note: Add a space between
fields.