Microcom 428T - Manual (Page 135)

Chapter 5 Printer Commands
428T Operator’s Manual - 880037-0140 5-61
11 2.5 ips
12 2.0 ips
13 1.5 ips
14 1.0 ips
15 0.5 ips
^A
^D COMMAND
X 156 Set Non-stick Time Interval:
This command is used to set the time interval for the Non-stick TOF mode
(D26 position 8) used to help alleviate the media adhering to the platen roller.
The value for X represents the number of seconds that the printer will execute
the Non-stick TOF operation. The default setting is 14400 or 4 hours. The
valid range is from 2 to 65536. This command is volatile and gets reset to the
default setting after power cycles and/or command reset conditions. The
^A1^D145 command may be used to observe the current setting and the
elapsed time counter.
X
157 Takeup Motor Run Time:
The D157 command is used with optional software that controls a DC Takeup
motor instead of a cutter motor. The value for X represents how long the
takeup motor will run, in milliseconds, after printing has stopped. This
command is a volatile command with a default of 0. The ^A1^D145 command
lists the current setting under the Post Takeup Time.
0 157 0
1
25 25 msec
2 50
3 75
4 100
5 125
6 150
7 175
8 200
9 225
10 250
11 275
12 300
13 325
14 350
15 375
16 400
17 425
18 450
19 475
20 500
21 525
22 550
23 575
24 600
25 625