Meinberg TCR LANTIME - Manual (Page 60)

Using the button “List detailed TCR information“ gives you the possibility to check
detailed TCR status information. The first parameter indicates the state of the
TCR510 clock and the state of the IRIG signal receiver. The next line will reflect
some IRIG status flags. The AGC is the automatic gain control of the internal
oscillator. The Drift will reflect the drift in micro seconds of the internal oscillator.
The last parameter will reflect the state of the internal NTP
Software Update
If you need to update the software of your LANTIME, you need a special file from
Meinberg, which can be uploaded to the LANTIME by first choosing the file on your
local computer with the “Browse” button and then press “Start firmware update”.
The chosen file will be uploaded to the LANTIME, afterwards you are prompted to
confirm the start of the update process. The scope of the update only depends on the
chosen file.
60