Measurement Computing PointScan Road Map rev.2.0 - Manual (Page 38)

8. In the Experiment Setup window, in the Global Settings frame (see above
figure), verify that Auto Select is unchecked and that the Block Size is set to 1.
9. In the Global Settings frame, under Sampling Rate/Ch, set the time value to the
match the value that was specified in the DataSocket Import Options box [step
3(h), page 33]. Set the units to Sec. The resulting scan rate, i.e., data return per
unit time, is for data to be returned once every 0.1000 seconds. This is equal to
10 samples/sec.
For each DASYLab worksheet module in the Experiment Setup window, set
the Block Size and the Sampling Rate to match that of the first module. This
will ensure that the data from each worksheet module coincides with the
data from the DataSocket Import module.
10. Close the Experiment Setup window.
11. From the Module pull-down menu, select Display, then select an appropriate
display module. This will allow you to see the data after the play button is clicked.
This completes the procedure for configuring DASYLab for PointScan.
DataSocket Import Module
attached to a Digital Meter Module
34 878395 PointScan Road Map