Measurement Computing PointScan Road Map rev.2.0 - Manual (Page 37)

3(f) For the channel that is being configured, select the desired “tag” by
highlighting it;
then click <OK>.
3(g) Click the <Options> button (following figure). The Data Socket Import
Options box will open.
Enter the time
value for the Scan
Rate. Step 3(h).
3(h) Enter the time value for the scan rate and Click <OK>. The resulting scan
rate, i.e., data return per unit time, is what we want DASYLab to use for the
PointScan device.
The previous figure indicates that we want to have data returned every 0.1000
seconds, (10 samples/sec). Note that the time factor entered here will later be
entered in the Experiment Setup window [step 9, page 34].
Click the <Options> button to open the
DataSocket Import Options box. Step 3(g).
4. Repeat step 3 for each of the remaining channels. Continue with step 5 after all
channels have been configured.
5. Click the <Save> button and save your setup under an appropriate filename and
location.
6. Close the DataSocket Import Setup box.
7. From the Experiment pull-down menu, select Experiment Setup.
An Experiment Setup box will appear (following figure)
.
Setting Block Size and Scan Rate in Experiment Setup
PointScan Road Map 878395 33