Measurement Computing Personal488 rev.3.0 - Manual (Page 55)

Personal488 for Windows 95/98/Me/NT/2000 04-09-01 Using IEEE 488 5-1
Using IEEE 488 5
IEEE 488 Configuration Utility …… 5-1
WinTest – Driver488 WorkShop …… 5-4
Differences Between 32-bit and 16-bit Driver488 Software …… 5-10
Programming Language Support …… 5-10
Microsoft Visual C++ …… 5-10
Borland C++ …… 5-11
Microsoft Visual BASIC …… 5-12
Borland Delphi …… 5-13
Support for Other Languages …… 5-13
16-Bit Driver488/W95 Compatibility Layer …… 5-13
IEEE 488 Configuration Utility
The IEEE 488 configuration utility is located in Windows Control Panel. The configuration utility is
primarily used to setup the Interfaces and External Devices. As seen in the following figure, it is similar to
the Device Manager.
Note: By default, the configuration utility always shows four interfaces (IEEE0, IEEE 1, IEEE 2,
& IEEE 3), even when only one interface is actually installed.
Interfaces
The minimum requirement for configuring your system is to make certain the IEEE 488.2 interface is
properly selected and configured.
The Interface Hardware box lists all the
available interfaces. In the figure, IEEE0
is assigned to a Personal488/PCI
interface.