Measurement Computing Personal488 rev.3.0 - Manual (Page 32)

Windows NT
3-22 Installation 04-10-01 Personal488 for Windows 95/98/Me/NT/2000
4. Physically configure the device’s jumpers and switches to match the resource settings Windows is
reporting during the driver installation. If these settings conflict with other hardware, change the
jumpers, switches, and Windows Resource settings to available resources.
Reference Note:
Refer to Chapter 4, Hardware Configuration Reference, for more information
regarding jumpers and switches.
5. Shutdown Windows and remove power from your PC.
6. Insert the interface board, securing it appropriately.
7. Return power to the PC.
This completes the installation procedure.