Measurement Computing Personal488 rev.3.0 - Manual (Page 31)

Personal488 for Windows 95/98/Me/NT/2000 04-10-01 Installation 3-21
Windows NT Users
Software Installation
Step 1
Insert the IEEE488 Software CD. The CD has an auto-run program that will automatically start the
setup program when the CD is inserted into the CD ROM driver. If auto-run is disabled, use Explorer
to launch the Setup.exe found in the root directory of the CD.
Step 2
Follow the screen prompts to install the software, then proceed to hardware installation.
Hardware Installation
All Devices
Personal488/AT (AT488)
Personal488 (GP488Bplus)
Personal488/MM
Personal488/PCI
1. Access the Windows Control Panel and launch the IEEE488 configuration program.
2. Highlight your interface (typically IEEE0) and select Properties as shown below:
Selecting “Properties” and “System Resources”
3. Click the Systems Resources button.
If Personal488/PCI is selected, then the System Resources button is not available. Windows
NT is not a plug-and-play operating system, and thus changing resources on a Plug-and-Play
interface is not possible.