At488 specifications, Gp488b specifications, Gp488b/mm specifications – Measurement Computing Personal488 rev.3.0 User Manual
Page 148: At488 specifications …… d-2, Gp488b specifications …… d-2, Gp488b/mm specifications …… d-2
D-2 Hardware Specifications
03/16/01
Personal488 for Windows 95/98/Me/NT/2000
AT488 Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rates: 16-bit DMA: 1 Mbyte/s (reads), 800 Kbyte/s (writes); 8-bit DMA: 330
Kbyte/s (reads), 220 Kbyte/s (writes)
Dimensions: Full-size board, two card edges; occupies one ISA slot
IEEE 488 Connector: Accepts standard IEEE 488 connector with metric studs
Power: 1.0 A max @ 5 V from PC
Environment: 0 to 70
°C, 0 to 95% RH, non-condensing
DMA: 16-bit DMA on channels 5, 6, and 7; 8-bit DMA on channels 0, 1, 2, and 3 (jumper selectable)
Interrupts: IRQ 2, 3, 4, 5, 6, or 7 (8-bit slot); IRQ 3-7, 9-12, 14, or 15 (16-bit slot)
IEEE 488 I/O Base Address:
&H02E1
,
&H22E1
,
&H42E1
,
or
&H62E1
Multiple Boards: Up to four AT488 boards can be installed, sharing a single DMA channel and interrupt
line
GP488B Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rate: 8-bit DMA: 330 Kbyte/s (reads and writes)
Dimensions: Half-size board, one card edge; occupies one ISA slot
IEEE 488 Connector: Accepts standard IEEE 488 connector with metric studs
Power: 650 mA max @ 5 V from PC
Environment: 0 to 70
°C, 0 to 95% RH, non-condensing
DMA: 8-bit DMA on channels 0, 1, 2, and 3 (jumper selectable)
Interrupts: IRQ 2, 3, 4, 5, 6, or 7
IEEE 488 I/O Base Address:
&H02E1
,
&H22E1
,
&H42E1
, or
&H62E1
Multiple Boards: Up to four GP488B boards can be installed, sharing a single DMA channel and interrupt
line
GP488B/MM Specifications
Note:
(1) GP488B/MM is only compatible with the Ampro PC/104. (2) Only GP488B/MM Revision B
is discussed in this manual. (3) Microswitches 6, 7, and 8 on switch SW1 do not have a function
on this board. (4) These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rate: 8-bit DMA: 330 Kbyte/s (reads and writes)
Connector: 26-pin header ribbon cable to IEEE 488 standard connector
Power: 650 mA @ 5 V from PC
Environment: 0 to 70°C; 0 to 95% RH, non-condensing
DMA: 8-bit DMA on channels 0, 1, 2., and 3 (jumper selectable)
Interrupts: IRQ 2, 3, 4, 5, 6, or 7
IEEE 488 Base I/O Addresses:
&H02E1
,
&H22E1
,
&H42E1
, or
&H62E1