Measurement Computing Personal488 rev.3.0 - Manual (Page 41)

Personal488 for Windows 95/98/Me/NT/2000 04-09-01 Hardware Configuration Reference 4-1
Hardware Configuration Reference 4
AT488 Configurations …… 4-3
GP488B Configurations …… 4-7
GP488B/MM Configurations …… 4-11
Hardware Configuration
Plug-and-Play Devices
Plug-and-play devices require no physical configuration of hardware. After installing your software and
hardware [as described in Chapters 2 and 3] the configuration is performed automatically. Note that the
plug-and-play devices are listed in the following table as a product reference only. This chapter contains
no useful information concerning plug-and-play devices.
Non Plug-and-Play Devices
The I/O base address, IRQ, and DMA settings of non plug-and-play devices are determined by the
physical settings of jumpers and DIP switches. This chapter provides the information necessary to
configure these devices.
Plug-and-Play Devices Non Plug-and-Play Devices
PCI488 AT488
Automatic
Configuration.
See page 4-3.
AT488pnp GP488B
Automatic
Configuration.
See page 4-7.
CARD488 GP488B/MM
Automatic
Configuration. See page 4-11.
Note: The device images are not shown to the same scale.