Measurement Computing Personal488 rev.3.0 User Manual
Page 135
Personal488 for Windows 95/98/Me/NT/2000
04-10-01
API Error Codes A-3
70
DMA CHANNEL %d DOES NOT EXIST
Specified DMA channel does not exist. Check hardware
settings.
71
DMA CHANNEL %d NOT AVAILABLE
Specified DMA channel is not available for use by Driver.
Choose another channel.
72
DMA CHANNEL %d ALREADY IN USE
Specified DMA channel is already being used by another
device. Choose another channel.
73
UNABLE TO ALLOCATE MEMORY FOR
ASYNCHRONOUS I/O
Internal system error. Report to factory.
74
UNKNOWN DOS DEVICE NAME
Driver488 DOS device name not known. Must create
Driver488 DOS device name with the Make Dos Name
command.
75
UNABLE TO ALLOCATE MEMORY FOR NEW DEVICE
Ran out of memory. Remove some devices to restore
memory.
76
UNKNOWN SLAVE DEVICE
Internal system error. Report to factory.
77
SLAVE DEVICE NOT SPECIFIED
Corrupt initialization file. Run the Install program.
78
UNABLE TO CREATE DOS DEVICE NAME
Internal system error. Report to factory.
79
UNABLE TO INITIALIZE DEVICE
Corrupt initialization file. Run the Install program.
80
ATTEMPTED TO REMOVE SLAVE DEVICE
Attempt to remove device which is required for operation
by another device.
81
DATA OVERRUN
Serial input overflow.
82
(None)
(None)
83
FRAMING ERROR
Serial data corrupt. Possible incorrect Serial port
configuration.
84
TIME OUT ON SERIAL COMMUNICATION
Serial device did not respond.
85
UNKNOWN PARAMETER OF TYPE %d SPECIFIED
:\n %s = %s
Internal system error. Report to factory.
86
BUS ERROR - NO LISTENERS
No Listeners found on bus.
87
TIME OUT ON MONITOR DATA
Expected terminator was not received.
88
INVALID VALUE SPECIFIED
Specified value is invalid for application. See command for
proper value types.
89
NO TERMINATOR SPECIFIED
Terminator must be specified. Check terminator value.
90
NOT AVAILABLE IN 8-BIT SLOT
Specified option is not available when the I/O adapter is
fitted into an 8-bit slot.
91
TOO MANY PENDING EVENTS
Internal system error. Report to factory.
92
BREAK ERROR
Serial receiver detected break.
93
UNEXPECTED CHANGE OF CONTROL LINES
Handshake lines changed during transmission.
94
TIME OUT ON CTS
Hardware handshake not satisfied within time out. Check
cabling and connected device.
95
TIME OUT ON DSR
Hardware handshake not satisfied within time out. Check
cabling and connected device.
96
TIME OUT ON DCD
Hardware handshake not satisfied within time out. Check
cabling and connected device.
97
CANNOT SEND EOI WITHOUT DATA
Transmission of EOI was requested when no data was
available to send.
98
ADDRESS STATUS CHANGE DURING TRANSFER
Talker/Listener mode changed during data transfer,
possibly due to activity of some other device on the
IEEE 488 bus.
99
UNABLE TO MAKE NEW DEVICE
MakeDevice or CreateDevice was unable to create a new
device, possibly due to the number of devices which
already existed.
100
(None)
(None)
101
COMMAND SYNTAX ERROR: %
Command interpreter was unable to interpret command and
no other information was available.
102
ERROR OPENING DEVICE %s
Possible loss of electrical or logical connection.
103
DEVICE %s CURRENTLY LOCKED BY %s
Device is in use by another processor in a multiprocessing
environment. (This does not refer to multitasking
environments.)