Appendix d - hardware specifications, Hardware specifications, Pci488 specifications – Measurement Computing Personal488 rev.3.0 User Manual
Page 147: At488pnp specifications, Card488 specifications, D – specifications …… d-1, Appendix d

Personal488 for Windows 95/98/Me/NT/2000
03/16/01
Hardware Specifications D-1
Appendix
D
AT488pnp Specifications …… D-1
GP488B/MM Specifications …… D-2
Hardware Specifications
PCI488 Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rate: 32-bit: 1 Mbyte/s (reads and writes)
Dimensions: Half-size board; occupies one PCI slot
IEEE 488 Connector: Accepts standard IEEE 488 connector with metric studs
Digital I/O Connector: Standard 9-pin female DSUB connector
Power: 500 mA max @ 5 V from PC
Environment: 0 to 70
°C, 0 to 95% RH, non-condensing
Digital I/O: Each signal can source 2 mA @ 3.7 V (6 mA @ 3.2 V) and
sink 2 mA @ 0.4 V (6 mA @ 0.9 V)
Multiple Boards: Up to four PCI488 boards can be installed into one PC
AT488pnp Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rates: 16-bit DMA: 1 Mbyte/s (reads), 800 Kbyte/s (writes)
Dimensions: Full-size board, two card edges; occupies one ISA slot
IEEE 488 Connector: Accepts standard IEEE 488 connector with metric studs
Digital I/O Connector: Standard 9-pin female DSUB connector
Power: 1.0 A max @ 5 V from PC
Environment: 0 to 70
°C, 0 to 95% RH, non-condensing
DMA: 16-bit DMA on channels 5, 6, and 7
Interrupts: IRQ 3, 4, 5, 7, 10, 11, 12, or 15
Digital I/O: Each signal can source 2 mA @ 3.7 V (6 mA @ 3.2 V) and
sink 2 mA @ 0.4 V (6 mA @ 0.9 V)
Multiple Boards: Up to three AT488pnp boards can be installed into one PC
CARD488 Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device: IOT7210
Maximum Transfer Rate: 1 Mbyte/s (reads and writes)
Dimensions: Type II (5 mm) PCMCIA card
Bus Interface: PCMCIA PC Card Standard 2.1
IEEE 488 Connector: Accepts standard IEEE 488 connector with metric studs via custom cable
Cable: PCMCIA to IEEE 488, CA-137 (included)