Measurement Computing WEB-TEMP - Manual (Page 9)

9
Chapter 2
Installing the WEB-TEMP
What comes with your shipment?
The following items are shipped with the WEB-TEMP.
Hardware
 WEB-TEMP
 Ethernet cable (standard)
You can optionally purchase a crossover cable (CAT-5 or higher) to connect the WEB-TEMP to an
Ethernet card installed in a computer.
 External power supply and cord – 10 watt AC power adapter. MCC part number PS-5V2AEPS.
Software
 MCC DAQ Software CD
Documentation
 Quick Start Guide
This booklet provides an overview of the MCC DAQ software you received with the device, and includes
information about installing the software. Please read this booklet completely before installing any software
or hardware.
 Setup Options
An overview of installation options is provided in the WEB-TEMP setup options that ships with the device.
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the WEB-TEMP from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, contact us immediately using one of the following methods:
 Knowledgebase:
kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
website at
www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
Connecting the AC power adapter
Power to the WEB-TEMP is provided with the 10 watt AC power adapter (PS-5V2AEPS). Connect the adapter
cord to the power connector on the WEB-TEMP device, and plug the AC adapter into an electrical outlet.
The POWER/COMM LED illuminates when +5 V power is supplied to the WEB-TEMP. If the voltage supply is
less than +4.75 V or more than +5.25 V, the POWER/COMM LED will not light.
Refer to Figure 11 on page 23 for the location of the POWER/COMM LED.