Measurement Computing USB-QUAD08 - Manual (Page 18)

USB-QUAD08 User's Guide Functional Details
18
External components
The USB-QUAD08 has the following external components, as shown in Figure 15.
 10 Screw terminal banks
 37-pin I/O connector (J12)
 Device Power and Status LEDs
 USB connector
 Counter/encoder channel LEDs (not shown below, refer to Figure 2 on page 8 for each location)
1 Counter input 1 connections 7 DIO2, 4, 6, 8, trigger, pacer, and power connections
2 Counter input 3 connections 8 Counter input 6 connections
3 Counter input 5 connections 9 Counter input 4 connections
4 Counter input 7 connections 10 Counter input 2 connections
5 DIO1, 3, 5, 7, ENC+ IN, power connections 11 Counter input 0 connections
6 USB connector and LEDs (Figure 16) 12 37-pin I/O connector (J12)
Figure 15. USB-QUAD08 external components
The LEDs and USB connector locations are shown in Figure 16.
1 Power LED (top) and Status LED (bottom) 2 USB connector
Figure 16. Power/Status LEDs, USB connector (device left side)
Screw terminals
The device has ten banks of detachable screw terminals that provide the following connections:
 Eight encoder/counter inputs
 Eight DIO, or six DIO and two timer outputs
 Clamp for CEMF suppression
 External trigger input
 External pacer input
 External encoder power input
 Eight encoder power outputs
 Power outputs
 Ground