beautypg.com

Denon AVR-887 User Manual

Page 6

background image

Getting Started

Getting Started

3

ENGLISH

ENGLISH

Cautions on installation

Wall

Note

Note:
For heat dispersal, do not install this unit in a confined space such
as a bookcase or similar enclosure.

Before using

Pay attention to the following before using this unit:

• Moving the unit.

To prevent short-circuits or damaged wires in the connection cables,
always unplug the power supply cord and disconnect the connection
cables between all other audio components when moving the unit.

• Cautions on using mobile phones.

Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.

• Before turning the power operation button on.

Check once again that all connections are correct and that there are
not problems with the connection cables. Always set the power
operation button to the standby position before connecting and
disconnecting connection cables.

• Store the operating instructions in a safe place.

After reading the operating instructions, store them in a safe place
as they could come in handy in the future.

• Whenever the power operation button is in the STANDBY state,

the unit is still connected to AC line voltage.
Please be sure to turn off the power operation button or unplug
the cord when you leave home for, say, a vacation.

• Note that the illustrations in these instructions may differ from

the actual unit for explanation purposes.

About the remote control unit

In addition to controlling the AVR-887, the attached remote control
unit (RC-1043) can also be used to control the following products:
q DENON component products
w Component products other than DENON:

• Set using the preset memory function (

page 65).

Inserting the batteries

q Remove the remote control

unit’s rear cover.

w Set two R6P/AA batteries in

the battery compartment in
the indicated direction.

e Put the rear cover back on.

Notes on batteries:
• Replace the batteries with new ones if the set does not operate

even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)

• When inserting the batteries, be sure to do so in the proper

direction, following the “<” and “>” marks in the battery
compartment.

• To prevent damage or leakage of battery fluid:

• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries

in flames.

• Remove the batteries from the remote if it will not be in use for

long periods.

• If the battery fluid should leak, carefully wipe the fluid off the

inside of the battery compartment and insert new batteries.

• When replacing the batteries, have the new batteries ready and

insert them as quickly as possible.

Operating range of the remote control unit

30°

30°

Approx. 23 feet/7 m

• Point the remote control unit at the remote sensor when operating

it.

• The remote control unit can be used from a distance of approximately

23 feet/7 meters, at a horizontal angle of up to 30° with respect to
the sensor.

NOTE:
• It may be difficult to operate the remote control unit if the remote

sensor is exposed to direct sunlight or strong artificial light.