English – Denon AVR-887 User Manual

Page 25

Connecting Other Sources

ENGLISH

¢ AM loop antenna assembly

Connect to the AM

antenna terminals.

Remove the vinyl tie
and take out the
connection line.

Bend in the reverse
direction.

a. With the antenna on

top any stable
surface.

b. With the antenna

attached to a wall.

Mount

Installation hole Mount on wall, etc.

An F-type FM antenna cable plug can be connected directly.

Connecting the antenna terminals

Direction of broadcasting station

75 Ω/ohms Coaxial cable

FM antenna

FM indoor antenna (Supplied)

AM loop antenna

(Supplied)

AM outdoor antenna

Ground

Connection of AM antennas

1. Push the lever.

2. Insert the conductor.

3. Return the lever.

Connecting the XM terminal

• AVR-887 is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM

Passport System (sold separately) and subscribing to the XM service.

• Plug the XM Passport System into XM terminal on the rear panel.
• Position the XM Passport System near a south-facing window to receive the best signal.

For details, see “XM Satellite Radio” (

page 38, 39).

When making connections, also refer to the operating instructions of the XM Passport System.

NOTE:
• Keep the power supply cord unplugged until the XM Passport System connection has been completed.

AUX OUT

XM Passport System

NOTE:
• Do not connect two FM antennas

simultaneously.

• Even if an external AM antenna is used, do

not disconnect the AM loop antenna.

• Make sure the AM loop antenna lead

terminals do not touch metal parts of the
panel.

Note to CATV system installer:
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC which provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.