beautypg.com

Denon AVR-887 User Manual

Page 16

background image

ENGLISH

ENGLISH

Easy Setup Procedure

Easy Setup Procedure

13

Measures

Cause

Example

q This screen will be displayed when the speakers required

for producing suitable reproduction have not been detected.

• Check that the pertinent speakers are properly connected.

w This screen will be displayed when the speaker polarity is

connected in reverse.

• Check the polarity of the pertinent speakers. For some

speakers, this screen may be displayed even though the
speakers are properly connected.
If so, select “Skip

0

”.

e This screen will be displayed when accurate measurements

cannot be made due to the input level of the microphone being
too high.

• Set up the speakers so that their position is farther away

from the listening position.

• Lower the volume of the subwoofer speaker.

Error messages

• These error screens may be displayed when performing Auto Setup measurement and the automatic measurements can not be completed

because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent
items, and measure again.

• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when

the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.

Press

D

D H

H

to select the items, then press

F

F

.

r This screen will be displayed when the measurement

microphone is not connected.

• Connect the measurement microphone to the microphone

connector.