beautypg.com

Denon AVR-887 User Manual

Page 14

background image

ENGLISH

ENGLISH

Easy Setup Procedure

Easy Setup Procedure

11

e Perform the Auto Setup procedure

Press

D

D H

H

to select “Auto Setup / Room EQ”, then

press

ENTER

.

Press

SYSTEM SETUP

.

Press

D

D H

H

to select “Auto Setup”, then press

ENTER

.

The message “Connect Microphone” is displayed if no
microphone is connected. If so, connect the auto setup
microphone.

1
2

3

• “System Setup Menu” is not displayed when using headphones.

1

2

3

r Assigning power amplifiers

Press

D

D H

H

to select “Power Amp Assign”, then press

F

F

G

G

to set.

The surround back output can be assigned to the “Front” or “ZONE2”
output.

Front A, Front B:

Assign to use the “Front A” or “Front B” speakers with bi-amp
connections.

Surround Back:

Assign to use as surround back speaker.

When assigned to “Front” or “ZONE2”, skip the surround back
channel measurement.
During the auto setup procedure, test tones are not output to
“ZONE2”.

ZONE2:

Assign to use as “ZONE2” speakers.

t Switching the front speaker

Press

D

D H

H

to select “Front Sp”, then press

F

F G

G

to select

the speaker.

Front A

Front A+B

Front B

Press

or

[ON/SOURCE]

.

• The power indicator blinks green and the power turns on.

Press

.

£

OFF:

The power turns off and the indicator is off.

¢

ON:

The power indicator lights red.

Turn on your subwoofer.

Set the volume to halfway and set the crossover frequency to
the maximum or Low pass filter off if your subwoofer can adjust
the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn this
function off before performing the Auto Setup procedure.

Turn on your monitor.

w Before performing the Auto Setup procedure

1

2
3

4

Set

[MODE SELECTOR 1]

to “AUDIO”.

5