Legrand 363292-01 - Manual (Page 2)

301 Fulling Mill Road, Suite G
Middletown, PA 17057
(800) 321-2343
©2012 by Legrand. All Rights Reserved.
www.legrand.us/onq
Using the Punch & Go Tool
3.
How To sTeP-by-sTeP CoNT.
Step 4
Place the fanned wires into the
appropriate color coded terminals and
press until fixed.
Step 5
insert the connector using the guide rails
on either side of the Punch & Go tool and
the connector.
Step 6
Firmly compress the handle of the
Punch & Go tool to terminate and cut
excess wire.
Step 7
Place the cap on the back of the
connector and press to make sure it is
fully seated.
Step 8
We recommend that you always test for
continuity. After placing your completed
connector into the wall, plug a short
RJ45 jumper cable into the connector.
Plug the other end of the jumper cable
into the tester.
Step 9
Place the other tester at the end of the
connector cable (at the enclosure) and
look for the green light.