Is-0345 rev. b – Legrand VM7632 User Manual

Page 2

INSTRUCTION / INSTALLATION SHEET
2X2 Enhanced Bi-Directional Video
Amplifier Module

IS-0345 Rev. B

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 2 of 2

Figure 3

INSTALLATION

WARNING - to reduce the risk of fire or electric shock, do not expose this to rain or moisture.

Note to CATV Installer: This reminder is provided to call CATV systems installer’s attention to Section
820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the
cable shall be connected to the grounding system of the building, as close to the point of cable entry as
practical.

Refer to Figure 3 during installation.

Snap the 2x2 Video Amplifier onto the included bracket.

To mount the bracket (with module) into the enclosure, insert the tabs on the left side of the bracket into
the slots in the enclosure and push the bracket pushpin into an appropriate hole in the enclosure to
secure the bracket (with module) to the enclosure.

C. Provide power to the amplifier module
D. Connect the incoming service line such as cable TV (CATV) or antenna (ANT) to the “CATV/ANT” port on

the amplifier.

Connect a coaxial patch cable from the “OUT” port on the 2x2 module to the “CATV/ANT” port on a 1x4,
1x6, or 1x8 passive video module to distribute the signal throughout the home.

To create an internal video network, connect all internal video sources to a separate 1x4, 1x6, or 1x8
passive video module. Connect a coaxial patch cable from the “CATV/ANT” port on the passive video
module to the “AUX IN” port on the 2x2 Modular Video Amplifier Module. This will make all internal video
sources viewable through all external ports on the passive video modules.