Legrand F7510 User Manual

Is-0411 rev. o

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 1 of 2

INSTRUCTION/INSTALLATION SHEET
3-Bay Module Mounting Bracket

IS-0411 REV. O

1. Introduction

The On-Q/Legrand 3-Bay Mounting Bracket (P/N F7510) is designed to mount up to three single bay modules in
virtually any enclosure, including all On-Q styles as well as Leviton and Open House enclosures.

2. Description

The On-Q 3-Bay Module Mounting Bracket, is designed to be mounted in the enclosures with multiple push-pins
(typically one at each corner) in one of two orientations (see Figure 1 and call out for video (RF coax) module
installations and Figure 2 and call out for phone and data (Cat 5e) module installations. Up to three single bay
modules) can then be mounted in the bracket, using push-pins at the corners of the modules.

3. Installation

The On-Q 3-Bay Module Mounting Bracket is typically installed during “trim-out” or as an upgrade for an existing
installation.

A. Bracket installation for use with Video Modules.

1. Hold the bracket so that the module openings are pointing

upward.

2. Insert one grommet into each of the four holes on the inside of

the bracket (see Figure 1 and its callout and Figure 3).

NOTE: The brackets are designed to work with other
manufacturer’s enclosures. Use Figure 3 as a reference for
which holes to use with which manufacturer. (#1 = Greyfox or
Pass and Seymour, #2 = Open House or Leviton and #3 = On-Q.
3. Insert a plunger into each grommet and pull back on the

plungers, once inserted, to insure they are unlatched.

4. Line up the bracket with the appropriate holes in the enclosure,

and push in the plungers to latch the grommets and lock the
bracket to the enclosure.

Secure
modules here
with push-pins

Figure 3