Legrand F9001 - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 1 ©Copyright 2005 by On-Q/Legrand All Rights Reserved.
INSTRUCTION/INSTALLATION SHEET
6-Bay Mounting Bracket
IS-0322 REV. O
1. Introduction
The On-Q 6-Bay Mounting Bracket (P/N F9001 as shown below) is designed to mount up to three double bay
or 6 single bay GF style modules in virtually any enclosure, including all GF and On-Q styles as well as
Leviton and Open House enclosures.
2. Description
The On-Q 6-Bay Mounting Bracket, (see Figure 1) is designed to be mounted in the enclosures with multiple
push-pins (typically one at each corner). Up to three GF style double bay modules (or up to six single bay
modules) can then be mounted in the bracket, using push-pins at the corners of the modules.
3. Installation
The On-Q 6-Bay Mounting Bracket is typically installed during “trim-out” or as an upgrade for an existing
installation.
a. Align the holes at the outside of the inner flange of the bracket with those in the enclosure and use push-
pins to secure the bracket to the enclosure (see Figure 1).
b. To attach double (or single) bay modules, align the push-pins on the module with the holes on the outer
flange of the bracket and push in the pins to secure the module to the bracket (see Figure 1).
c. Pull lightly on the module to assure it is properly locked in place.
Figure 1
Secure plate here
with push-pins
P/N F9001
Secure
modules here
with push-pins