Legrand F7596-xx User Manual

Is-0368 rev. o

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 1 of 2

INSTRUCTION/INSTALLATION SHEET
inQuire™ 1000 Intercom Door Unit

IS-0368 REV. O

Reserved

1. Introduction

The On-Q /Legrand inQuire™ 1000 Intercom Door Unit, PN F7596-XX (see
Figure 1), is a weather resistant door unit that allows a visitor to notify the
occupants of their presence by pushing the door chime button (requires Door
Chime to be installed). The occupants can then initiate two-way
communications with the visitor and open the door (requires separate door
release device). The Door Unit is available in white (-WH), shiny brass (-SB),
antique brass (-AB), brushed stainless (-BS), or oil-rubbed bronze (-OB).

2. Description

The Door Unit is weather-resistant and contains a speaker, microphone and
button to ring the door chime (requires Door Chime to be installed). The high
quality speaker and microphone provide superior sound quality. The Door
Unit is installed in a 2-gang outdoor weatherproof box typically at electrical
switch box height.

3. Installation

Installation of the inQuire™ 1000 Door Unit is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall and siding is installed, and at “Trim-out” after the drywall is installed.

A. “Rough-in” steps:

1. Run a Cat 5 cable from the Enclosure where the inQuire™ 1000 Intercom Module will be installed to the

2 gang box at the Door Unit location.

NOTE: It is important to keep all Category 5e cable runs, regardless of use, at least 12 inches away
from AC electrical cables. If it proves necessary to cross an existing AC cable, do so only at a 90
degree angle.

B. “Trim-out”

steps:

NOTE: All terminations can be correctly completed by following the T568A pin assignments. It is
important that you accurately terminate using T568A at all locations. There are two different types of
terminations you will encounter when installing the inQuire™ 1000 Intercom System: RJ45 plugs on the
Modules, the Main Console and the Room Unit and 110 punchdown blocks on Door and Patio Units. Refer
to Figure 2 for correct T568A termination for both RJ45 plugs and 110 punchdown blocks.

Figure 1

Figure 2