Legrand F7601 User Manual

Is-0372 rev. o

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET
inQuire™ 1000 Intercom Door Chime

IS-0372 REV. O

Reserved

1. Introduction

The On-Q /Legrand inQuire™ 1000 Intercom Door Chime, PN F7601
(see Figure 1), is a component that installs as an add-on to the
inQuire™ 1000 Intercom Module that enables a chime to be heard at
each intercom location throughout the house.

2. Description

The Door Chime attaches to the rear of the inQuire™ 1000 Intercom
Module in the enclosure (see Figure 2). When a visitor presses the
door chime button on the inQuire™ 1000 Door Unit, a chime is heard
on each inQuire™ 1000 system device (eg. Room Unit) that contains
a speaker.

3. Installation

Installation of the inQuire™ 1000 Door Chime can occur at any time, as long as the inQuire™ 1000 Intercom
Module in the enclosure is available.

NOTE: If the inQuire™ 1000 Intercom System is already installed and functional, you will need to first
remove power from the Intercom Module before attaching the Door Chime to the rear of the Module.

A. Place the Door Chime board on the rear of the

Intercom Module so that the two mounting
holes on the Door Chime are seated over
the threaded studs on the rear of the
Intercom Module.

B. Ensure that the Door Chime’s pin array lines

up with the socket on the rear of the Intercom
Module and apply slight pressure to seat the
Door Chime.

C. Use the included washers and hex nuts to

secure the Door Chime to the Intercom
Module.

D. If the user wishes to hear the doorchime play

through the Door Unit when the button is
pressed, remove the shunt from Jumper #2
on the rear of the Intercom Module.

E. Re-apply power to the Intercom Module and

have someone press the Door Chime button
on a Door Unit. You should hear the chime at
any inQuire™ 1000 Intercom system location.

Figure 1

Figure 2

Rear of Intercom Module