Legrand MRR2 - Manual (Page 7)

Set HOuSe id
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
IMPORTANT: Because the repeater increases the range of the Miro wireless
system, it is very important to make sure the repeater is installed and powered
before setting the House ID using any other Miro wireless device. The repeater
automatically checks for House IDs that are installed in the neighborhood.
new installation
1. With all devices installed and
energized, make sure that every
Miro wireless device LED is
yellow. If any LED is off, be sure
the circuit breaker is on and the
device is correctly installed.
2. Press on any device until the
LED flashes yellow (about 2
seconds). This indicates that it
has acquired a unique House ID.
3. Make sure that all other Miro wireless device LEDs are flashing green,
indicating that they have acquired the same House ID.
4. Return to the device used in step 2, which is still flashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in the
House change to solid green, indicating house binding is complete.
Adding a device to an existing installation
If you’re adding or replacing a device in a Miro wireless installation that is
already operating, the new device must acquire the same House ID as the other
Miro wireless devices in the house. After the new device is powered up, the LED
should be solid yellow. This indicates that it has not yet acquired a House ID. To
acquire the House ID for the existing system:
1. Press on any previously bound device until the LED flashes yellow (about 2
seconds).
2. Verify that the newly added device LED is flashing green, indicating that it has
acquired the House ID.
3. Return to the same previously bound device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should now
be solid green.
REPEATER 2 FINGERS
When you see
in the instructions,
firmly press and
hold both buttons
on the MRR2 until
the LED changes
(about 2 seconds).