Legrand 364596-01 - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 1
INSTRUCTION/INSTALLATION SHEET
12-PORT VIDEO INTERFACE MODULE
IS-0191 REV. A
©Copyright 2007 by On-Q/Legrand All Rights Reserved .
1. Introduction
The On-Q/Legrand 12-Port Video Interface Module, P/N 364596-01, provides a convenient interface for coaxial cables
in the On-Q enclosure. The individual cables can then be jumpered to On-Q Video Modules for the amplification,
combining and distribution of these signals. The Interface Module also provides a convenient location for the
termination of any unused coaxial cable to be used in future applications. This module can be installed directly into
any On-Q style enclosure.
2. Description
The On-Q 12-Port Video Interface Module is a half width module (2.00” H
x 6.42” W), which is mounted utilizing the On-Q style tab and plunger
arrangement. This Video Module has 12 low-loss “F” style fittings for
connecting all incoming and outgoing signals. The module allows for 12
signal inputs/outputs. The module plate is black powder coated steel
(see Figure 1).
3. Installation
A. Mounting into an On-Q enclosure (see Figure 2)
1. Select the location in the enclosure to allow easy access of the input and output cables.
2. Align the tabs on the module with the slots in the enclosure. Insert the tabs by angling the module away from
the back of the enclosure.
3. Rotate the module and insert the plunger/grommet on the module into the corresponding hole on the back
plane of the enclosure. (Plunger must be in pulled out position for it to engage the hole)
4. Push the plunger in to lock the module in place. Pull on the module to ensure the module is locked properly
in place.
B. Cable Connections
1. Identify cable(s) and route to fitting(s) on module. In
routing cable, allow slack for bundling cables to the side.
Trim cable to allow lose loop of cable to the connection.
2. Attach a Series 6 “F” connector to the cable. Connect to
fitting on module and finger-tighten.
3. Attach RG6 cables from module to desired locations in
enclosure.
NOTE: Recommended location for this module is the upper
left side; however, module may be mounted in any available
space.
Figure 1
Figure 2