Legrand AC1030 - Manual (Page 2)

INSTRUCTION / INSTALLATION SHEET
HDBase-T HDMI Extender
IS-1507140 Rev. C
301Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2012 by Legrand All Rights Reserved. Page 2 of 2
3. Installation
a. As shown in Figure 3, install the AC1030 transmitter unit near the HDMI source device (such as a DVD
player or projector) and install the AC1030 receiver near the receiving device (such as a TV).
b. The DVD player or projector is connected to the AC1030 transmitter
HDMI “IN” port with an HDMI cable
(not included) and the TV is connected to the AC1030 receiver HDMI “OUT” port with an HDMI cable
(not included).
c. The AC
1030 transmitter and receiver are then connected via a Cat 5e or Cat 6 cable up to 100m (328’)
in length to the port labeled as “HDBase-T” on each unit.
d.
The two ports labeled “100Base-T” on each unit may then be connected to any devices (such as PCs) or
to an internet connection to extend a local LAN between units.
e. On the opposite side of each unit from the HDMI and Cat 5e/6 connectors are two IR ports labeled
“IR-
RX ” and “IR-TX” and several LEDs to indicate status (see Figure 4).
f.
To utilize the IR ports, connect the IR “RX” adapter to the “IR-RX” port on the AC1030 Receiver (typically
at the TV location) and the IR “TX” adapter to the “IR-TX” port on the AC1030 Transmitter (typically at
the DVD or projector location). This will allow you to use a remote control at the TV location to control
the DVD player at a remote location (see Figure 5).
g. When all connections have been made, plug the AC1030 Transmitter and Receiver units AC adapters
into an AC source. This completes the installation.
Figure 4
Figure 5