Legrand MS3523-BK - Manual (Page 2)

INSTRUCTION / INSTALLATION SHEET
evōQ™ 3000 5.25” Outdoor Speakers
IS-0257 Rev. C
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 2 of 2
D. Strip off 3 inches or so of the speaker cable jacket to expose
the positive and negative insulated wires. Strip 3/8-1/2 inch
of insulation off of these conductors.
NOTE: It is a good practice to coat the wire with a corosion
preventing gell. This will prevent oxidation and limit whicking
ofmoisture through the cable.
E.
Hold the speaker with one hand, (if speaker grill is off, pay
careful attention not to push on the woofer’s cone, this can
cause permanent contortion of the voice coil, thus producing
a mechanical rubbing sound or speaker failure) unscrew the
Red and Black screw terminals, insert the bare speaker
wires through the hole in each post, and tighten each screw
terminal. Be sure to have the positive wire in the RED
terminal and the negative in the BLACK (see Figure 4). As
you tighten each screw terminal wiggle the wire and
tighten some more.
NOTE: Wiring both speakers identically as the above
instruction states will yield speakers that are “in phase”. If one
speaker is wired opposite of the other, the speakers will be “out
of phase” with one another. If the speakers are “out of phase”
the sound might appear smeared (canned) and a significant
loss of bass might be noticeable due to phase cancellation.
Make sure every installed speaker is correctly phased.
F.
Once the speakers are wired correctly, attach them to the
bracket with the large round retainers provided with the
speakers (see Figure 5). The retainers allow the speakers to
be rotated in the bracket to direct the sound output.
evōQ™ 3000
Size/Type 5.25" Outdoor
Efficiency 90dB
Power (RMS/Peak) 50W/100W
Frequency
Response
65-20K
Woofer Type Poly
Tweeter Type 1" PEI Mylar
Speaker
Specifications
Figure 4
Figure 5