Legrand 364764-02-V1 - Manual (Page 3)

INSTRUCTION / INSTALLATION SHEET
evōQ™ 1000 6.5” Speakers
IS-1507010 Rev. A
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2006 by On-Q/Legrand All Rights Reserved. Page 3 of 3
NOTE: Wiring both speakers identically as the above
instruction states will yield speakers that are “in phase”.
If one speaker is wired opposite of the other, the
speakers will be “out of phase” with one another. If the
speakers are “out of phase” the sound might appear
smeared (canned) and a significant loss of bass might
be noticeable due to phase cancellation. Make sure
every installed speaker is correctly phased.
3 Use one hand to push the speaker into the cut out
(again, pay careful attention not to push on the woofer’s
cone, this can cause permanent contortion of the voice
coil, thus producing mechanical rubbing sound or
speaker failure) and the other to turn the screws that
engage the installation tabs (see Figure 5). Tighten the
tabs in a cross or X-pattern until “snug”. Be careful not
to over tighten the tabs or damage could result. The
speaker should appear flush to the surface.
NOTE: If using a cordless drill/screwdriver, it is
suggested that the screws be turned until almost tight,
then finish tightening via a hand screwdriver.
Figure 5
evōQ™ 1000 evōQ™ 1000
Size/Type 6.5" In-Ceiling 6.5" In-Wall
Efficiency 90dB 90dB
Power (RMS/Peak) 50W/100W 50W/100W
Frequency
Response
60-20K 60-20K
Woofer Type Poly Poly
Tweeter Type Mylar Mylar
Drywall Hole Size 7.75” dia. 7.5” x 10.75”
Speaker
Specifications