Legrand NV-WA40W - Manual (Page 9)

8
Step 4: Connect the optional back panel audio inputs. There are two hardwired audio
inputs on the back of the WA40W-AMP. They are labeled Input A and Input B. Two
individual audio sources can be wired to these inputs simultaneously. The actual source
for playback is selected from the front Panel A/B button, or from the A/B button on the
wireless remote control.
To make the termination, strip the left, right and ground leads on the input side of a
stereo RCA or stereo mini, 3.5mm audio cable. Terminate those leads into the
appropriate screw down terminals on the WA40W-AMP.
Step 5: When the desired inputs on the WA40W-AMP are complete, screw the
mounting plate into the installed back box.
Step 6: Snap the WA40W-AMP into the installed mounting plate and install the
screwless trim plate over the entire assembly.
The WA40W-AMP is now ready for operation. When it is turned on, the ON LED will
light. Any incoming signal wired to the back panel will be amplified to the attached
speakers. When an audio source is plugged into one of the front panel 3.5mm inputs, it
will automatically override the back panel inputs.