Legrand AU1011-WH - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
FLUSHMOUNT TRIPLE SOURCE
INPUT
IS-0406 REV. A
©Copyright 2008 by On-Q/Legrand All Rights Reserved .
1. Introduction
The On-Q/Legrand Flush Mount Triple Source Input, PN
AU1011-xx (see Figure 1), is a wall mounted fixed version of the
lyriQ™ Triple Source Input Unit. It is a component which, when
combined with other essential components and your audio
source equipment, creates a versatile whole-house multi-source
audio system that will fill your rooms with high-quality sound for
years to come. The Flush Mount Triple Source Input may be
combined with a Single Source Input to provide up to 4 audio
sources to the lyriQ™ Four Source, Eight Zone Distribution
Module in the enclosure. The Category 5 technology utilized for
whole house audio distribution with the lyriQ™ system provides
many advantages over other conventional methods of audio
distribution such as a low noise Category 5 wiring scheme, and
infrared control of system components. The Flush Mount Triple
Source Input is available in white (-WH), light almond (-LA) and
black (-BK).
2. Description
The Flush Mount Triple Source Input typically resides at the entertainment center location and is connected to
the enclosure-mounted lyriQ™ Four Source, Eight Zone Distribution Module (4x8) using two Category 5 cable
runs. The Flush Mount Triple Source Input receives up to three line level stereo audio outputs from the audio
source equipment. If your devices do not have dedicated line level or preamp output, use the tape monitor
outputs. The Flush Mount Triple Source Input provides three sets of RCA jacks for audio source equipment
connection and an adjustable gain control for each to balance the inputs. The green LED next to each set of
RCA jacks indicates an active audio source. IR signal distribution is supported by three (3) IR Emitter Output
ports (IR on Tip, no connection to Ring and Sleeve is grounded) and one (1) IR Target input port (+12V on
Tip, IR on Ring and Sleeve is grounded). The IR Target input is routed only to the three Emitter outputs. A red
LED is provided to indicate IR activity.
3. Installation
IMPORTANT: Read all technical information that is included with all associated lyriQ™ Audio
products before installation of any single component. If you are unsure of any of the following
installation procedures contact On-Q/Legrand Technical Support @ 1-800-321-2343 option 1 or
contact an On-Q/Legrand installer.
NOTE: The Flush Mount Triple Source Input, like other On-Q/Legrand lyriQ™ Audio system
components, is powered by the On-Q/Legrand lyriQ™ Four Source, Eight Zone Distribution Module.
A. Run two Category 5 cables from a two-gang low voltage bracket or electrical box at the room location
containing the Flush Mount Triple Source Input (typically the entertainment center location) to the lyriQ™
Four Source, Eight Zone Distribution Module located in the Enclosure.
B. Make sure that the Power Supply is not connected to the Audio Distribution Module at this time.
Figure 1