Legrand WP1010-BK - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 1
INSTRUCTION/INSTALLATION SHEET
Cat 5 CVDA STRAP
IS-0399 REV. O
©Copyright 2007 by On-Q/Legrand All Rights Reserved .
1. Introduction
The On-Q /Legrand Cat 5 Component Video Extender with Digital
Audio (Cat 5 CVDA) Strap, PN WP1010-xx (see Figure 1), is a wall
mounted decorator strap-based pre-configured product that supports
the transmission of a 1080i component video signal and 5.1 digital
audio (Sony/Phillips Digital Interface or SPDIF) stream over a single
Cat 5e cable. The face of the strap contains 4 RCA connectors with
Green, Blue, Red (component video) and Orange (SPDIF) dielectric
colors. The rear of the strap contains one Cat 5e jack and a 110-style
punch down strip. The Cat 5 CVDA Strap is available in white (-WH),
light almond (-LA) and black (-BK).
2. Description
The Cat 5 CVDA Strap is typically used in pairs, one behind the
high definition display and a second one behind the equipment
rack housing the high definition source components. The straps
are then connected together in-wall with a standard Cat 5e cable
(see Table 1 for recommended maximum lengths). Short
component video and digital audio (CVDA) cables are then used
from our strap to the display and from our other strap to the high
definition components, for a visually clean high performance
connection.
3. Installation
A. At rough in, run a Cat5e cable from a low voltage bracket at the high
definition display location to a low voltage bracket at the
entertainment center location.
B. At trim out, pull the Cat 5e cable through the low voltage bracket,
and either terminate both ends with Cat 5e plugs and plug them into
the Cat5e jacks or terminate the ends directly onto the 110-style
punch down strips at the rear of each strap (see Figure 2).
C. Mount the Cat 5 CVDA Straps into the low voltage bracket with
provided screws, and cover with the provided decorator wall plate,
retained by its provided screws.
D. Use an appropriate length CVDA cable from the display to the strap
behind the display and from the high definition components to the
strap behind them.
Figure 1
Figure 2
Resolutio
n
Cat
5e
Cat 6
1080i 35’ 50’
720p 50’ 75’
Table 1