Legrand CS Series 360° PIR - Manual (Page 5)

Call 800.223.4185 for Technical Support
MASKING
An insert (mask) is supplied to allow elimination of coverage in unwanted
areas.
The mask is cut as needed and mounted onto anchor pins in the sensor’s
cover.
IMPORTANT: Do not use the mask if full coverage is desired.
IMPORTANT: Before securing the sensor in the mounting location, the
assembled sensor must be turned so the unmasked portion of the lens
faces the coverage area (the blue masked area is visible through the lens).
IMPORTANT: For an already installed sensor—If the sensor can NOT be
turned, then the mask must be cut so that when installed it will be oriented
correctly (note the location of the securing pins in the cover and note that
the cover turns as it locks into position).
Note: At the edges of the masking, there is a small area of reduced
sensitivity, illustrated as the lighter area in the examples below.
WIRING DIRECTIONS
CAUTION
TURN POWER OFF AT CIRCUIT BREAKER BEFORE WIRING SENSOR
Pass & Seymour PWP2 series power packs supply power for up to 10
CS Sensors.
When using more sensors than this, multiple power packs are required.
To connect the low voltage wires from the power pack to the sensor:
• RED wire on sensor to RED wire (+24VDC) on power pack.
• BLACK wire (Common) on sensor to BLACK wire on power pack.
• BLUE wire (Control Output) on sensor to BLUE wire on power pack.
White (Neutral)
Red (Load)
Red (Line) White
Black Hot
N POWER PACK
Re
d
Bl
ac
k
Bl
ue
Switch
Control Output 24VDC BLUE
Wires
+24VDC RED
Common BLACK
CS Series
Sensor
Lighting
Load
Cut mask into sections
for desired coverage,
shown right.
Mask
Reduced sensitivity Coverage area