Legrand NME1250AP - Manual

NME1250AP
Nonmetallic Wireless Access Point
Mounting Enclosure
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: ED1327R1 – Updated July 2010
Legrand/Wiremold electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
CAUTION: To reduce the risk of electrical shock, always disconnect the network lines before servicing or disassembling this equipment.
Step 1 Step 2
Raceway
Access Point Open
Step 3 Trim around opening. Step 4
#10 Screw (Included)
Knife (Not included)
#10 Wall Anchor
(Included)