Legrand DS4000 Forward Facing Activation Plates - Manual

DS4000 Forward Facing
Activation Plates
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43265 – December 2005
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Identify the locations along the DS4000 Series Raceway Base where activations are needed.
Products Covered: DS4047D, DS4047R, DS4047C, DS4047MAB
Installed DS4000 Raceway Base DS4000WC Wire Management Clips
(included with DS4000 Series Raceway Base).
Step 2. Wire and mount Device to Mounting Bracket. Hook
Device Mounting Bracket into outer edge of Raceway
Base. Rotate Bracket down and snap bottom of
Bracket into place.
Hook Bracket into
Raceway Base. A #10-32 Ground Screw is provided
on all Device Brackets. Rotate Bracket down and
snap into place.
For more information, visit www.wiremold.com/ds4000.