Legrand DS4000 Elbow Fittings - Manual

DS4000 ™ Elbow Fittings
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43268 – January 2006
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Affix Fitting Base to mounting surface with
minimum #8 screws. (not included)
Step 3. All Fitting bases have similar features.
NOTE: the Raceway Cover Stop and
internal Snap Fingers.
Step 4. Install Raceway Covers as shown. Position raceway
cover section against cover stop and snap into place.
Step 2. Connect Raceway to Fitting with supplied
Adjust-to-Fit ™ Couplings.
Raceway Base
does not need
to butt against
Fitting Base.
Maximum
4" [102mm]
gap allowed.
Products Covered: DS4011, DS4017, DS4018
For more information, visit www.wiremold.com/ds4000.
Cover Stop
Cover Stop
Snap Fingers