Legrand DS4000 Downward Facing Activation Plates - Manual

DS4000 Downward Facing
Activation Plates
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43426 – December 2005
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Identify the locations along the DS4000 Series Raceway Base where activations are needed.
Products Covered: DSDWNR, DSDWND, DSDWNX
Installed DS4000 Raceway Base DS4000WC Wire Management Clips
(included with DS4000 Series Raceway Base).
Step 2. Wire Device and attach to Bracket. Snap into
place as shown.
Tighten
A #10-32 Ground
Screw is provided on
all device brackets.
Hook
Rotate and
Snap into
Place
Step 3.
For more information, visit www.wiremold.com/ds4000.
For installation of Downward Facing Devices (DSDWND, DSDWNR) fed from the lower channel
of DS4000 Raceway: