beautypg.com

Legrand DS4000 Couplings User Manual

Ds4000 couplings

background image

DS4000 Couplings

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 43267 – December 2005

Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.

All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.

j

Step 1. Use DS4001 Couplings to connect sections of DS4000B to each other and Transition Fittings.

Step 2. Coupling can slide in from the end of

the Raceway or snapped in as shown.

Products Covered: DS4001, DS4014A

For more information, visit www.wiremold.com/ds4000.

Step 3. The Coupling can also serve as a ground

clamp by adding a #10-32 Ground Screw.

Hook

NOTE: Couplings are included with DS4000B and with each Fitting.

Additional Couplings may be required depending on the installation.

Step 4. Where the Adjust-to-Fit Coupling

is too long, the Coupling can be trimmed at the notch and broken into a smaller

piece. Remove Screw from larger section and place in the open hole on the smaller piece.