Legrand DS4000 End Fittings - Manual

DS4000 End Fittings
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43427 – January 2006
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. Mount DS4010A Entrance End Fitting with
#8 fasteners (not supplied). 3/4" and 1 1/4"
trade size knockouts are provided on the
back and bottom of the Fitting for conduit.
Square 2" x 2" [51mm x 51mm] knockouts
are also provided for low voltage cabling.
Step 2. Install DS4000B Raceway Base, attach with #8
fasteners. Join with Adjust-to-Fit ™ Coupling.
Step 3. Snap DS4000C Cover on. Step 4. Snap DS4010A Cover straight on. Cover will
overlap DS4000C Raceway Cover
Products Covered: DS4010A, DS4010B, and DS4089
DS4010A INSTALLATION
For more information, visit www.wiremold.com/ds4000.
Adjust-to-Fit™
Coupling Bend Radius
Control Inserts
4" [102mm] Max
Adjustment