Legrand G-6012TX - Manual

G-6012TX
INTERNAL AND
EXTERNAL 45° ELBOW
INSTALLATION
INSTRUCTIONS
G-6012TX assembled as
45° internal elbow.
G-6012TX as 45° Internal Elbow…
G-6012TX assembled as 45°
external elbow.
The G-6012TX is fur-
nished disassembled.
For use with Plugmold
®
G-6000 raceway.
Wiremold Electrical Systems conform with,
and should be installed and properly grounded
in compliance with requirements of the current
National Electrical Code or codes administered
by local authorities.
All electrical products may represent a possi-
ble shock or fire hazard if improperly installed
or used. Wiremold electrical products are UL
listed, made for interior use and should be
installed by qualified electrical people in con-
formance with current local and/or National
Electrical Code.
Assemble elbow couplings, angle filler and
end pieces in positions shown by means
of pan head screws (furnished). Angle
filler is retained by flanges on end pieces.
Tighten all end piece screws securely.
1
Assemble G-6000 raceway base sections on G-6012TX elbow couplings so as to abut elbow
end pieces and tighten locking screws. Sawcut G-6000 cover flanges and bend cover 45° as
shown. After conductors are in place, snap G-6000 cover into raceway base sections.
2
PAN HEAD SCREWS (Furnished)
ELBOW COUPLING
ELBOW
COUPLING
ANGLE FILLER
(RETAINED BY
END PIECES)
END PIECE
END
PIECE
G-6012TX 45° INTERNAL ELBOW
G-6000 BASE
SAWCUT FLANGES AND BEND COVER
G-6000 COVER SECTION
G-6000
COVER
SECTION
LOCKING SCREWS
45°