Legrand ALDS4000 Designer Series Large Raceway Base - Manual

ALDS4000 Raceway
Base & Cover
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 43371R1 – Updated August 2007
Wiremold / Legrand Electrical Systems conform to and should be
installed and properly grounded in compliance with requirements
of the current National Electrical Code, Canadian Electrical
Code, or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
j
Step 1. If the installation requires Fittings, start at an
appropriate location such as a corner. Refer
to specific fitting installation instructions for
proper mounting. Attach Adjust-to-Fit
™
Couplings to Fittings and tighten.
Step 3. Butt succeeding ALDS4000B Sections to the
installed Base Section and mount using the
same method as in Step 2.
Step 4. Install the next Fitting. Place an ALDS4000B Base Section
in line with the last piece of Base that was mounted. Mark
where the Base lines up with the Fitting and cut at this
point. Precise cuts are not required since the Adjust-to-
Fit
™ Coupling will maintain the integrity of the Base where
there are any gaps between Sections. Adjust-to-Fit™
Coupling can span gaps up to 4" [102mm].
Products Covered: ALDS4000B, ALDS4000C.
Step 2. Slide ALDS4000B Base Section onto Couplings and
tighten Screws. Drill a hole in each Channel of the Base
at the first Stud to secure to the Wall using a #8 Fastener.
Secure to Wall no more than 48" [1.2m] apart.
For more information, visit www.wiremold.com/ds4000.
Stud Location
NOTE: ALDS4000B Raceway Base includes Couplings and Wire Clips.
Wire Clips are factory installed in the lower Channel of each
Raceway Base Section. Make sure Base Sections are properly
oriented prior to securing to the Wall
NOTE: For backfeeding raceway, a hole may be drilled into either channel
of ALDS4000B to connect 1 1/4 trade size or smaller conduit.