Legrand WSM Series Grommet - Manual

Wiremold ®
WSM Series Grommet
Installation Instructions
No: 1 010 853 – 0312
Catalog Number(s): WSMSTCBK, WSMSTCSL, WSMSTCWH, WSMSDTCBK, WSMSDTCSL, WSMSDTCWH,
WSCSTCBK, WSCSDTCBK, WSCSTCSL, WSCSDTCSL, WSMEUTBK, WSMEUTSL,
WSMEDUTBK, WSMEDUTSL, WSCEUTBK, WSCEUTSL, WSCEDUTBK, WSCEDUTSL,
• Read all InstRuctIons befoRe begInnIng
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if improperly
installed or used. Legrand/Wiremold electrical products may bear the mark
of a Nationally Recognized Testing Laboratory and should be installed in
conformance with current local and/or the National Electrical Code.
Country of Origin: Made in U.S.
Mounting Screws
Table Cutout
Mounting Hole
(Quantity 2)
1. Provide 5.25" x 3" [ 133mm x 76mm] cutout at
location Grommet will be mounted.
2. Install Grommet into cutout; be sure Grommet is
fully seated.
3. Insert mounting screws (not included) through
Grommet mounting holes and into work surface
as shown.
4. Ensure lid pivots freely through the entire motion
(for versions with lids only).
Grommet
(flush lid Version shown)
5 1/4"
[133mm]
3"
[76mm]
Single Portal Kits: WSMEDTC72SLSK, WSMEDTC60SLSK, WSMEDTC72BKSK,
WSMEDTC60BKSK
Double Portal Kits: WSMEDTC72SLDK, WSMEDTC60SLDK, WSMEDTC72BKDK,
WSMEDTC60BKDK