Legrand WSME Series Enhanced Power Base - Manual

Wiremold ®
WSME Series Power Base
Installation Instructions
No: 1 010 852 – 0312
Catalog Number(s): WSMEUTBK, WSMEUTSL, WSMEDUTBK, WSMEDUTSL
• Read all InstRuctIons befoRe begInnIng
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if improperly
installed or used. Legrand/Wiremold electrical products may bear the mark
of a Nationally Recognized Testing Laboratory and should be installed in
conformance with current local and/or the National Electrical Code.
Country of Origin: Made in U.S.
Recommended cutout:
5 1/4" x 3"
[133mm x 76mm]
Mounting screws
(not included)
optional data cutouts
1. Provide 5.25" x 3" [ 133mm x 76mm] cutout at
location Power Base will be mounted.
2. Attach Power Base to surface from underside using 6
screws (not included) as shown in Figure 1.
note: ensure screws do not pierce through
finish surface.
3. Connect power cables as shown in Figure 2.
4. Connect data jacks, if provided, as needed.
fIguRe 1
fIguRe 2
Power Box
cable end line up similar colors and
snap tgether connectors
as shown
Kits: WsMedut72slsK, WsMedut60slsK